I mostly wrapped up match drilling all of the rear spar today. Next steps, debur everything, prime and rivet. Progress will be delayed...

I drilled the doublers to the rear spar. I had to straighten the large think forked doublers, as they had a bow to then, but this was...

I countersunk the fastener holes, primed the bare holes, and then assembled the tie down brackets. I need to come up with a better set up...

I installed the rest of the nutplates today, then countersunk them as required. I sprayed all of the exposed mail with still etching...

I continued on the main spar today adding nutplates. I had some help loading rivets as I went. I also started working on the spacers for...

I started on the right spar by drilling, countersinking, riveting, and then countersinking the nutplates on the top flange of the main...

We sorted through the hardware bags and labeled them for ready access

I finished riveting the left elevator. The trim tab ended up with an unacceptable bulge, so I will remake it later. We then started...

While I don't need it yet, I found a wing kit for sale relatively close to me. After about 14 hours round trip worth of driving, it is...