I took some time from riveting to fit the tank sending unit. This is in the second bay since I have a flop tube. The float ends up just barely off the skins at the end of travel either direction.
I realized after the fact that I could have installed this stiffener outside of the tank.. Van's talks about the other end of the tank having issues if you do it in the reverse order since it has the large piece of angle that gets in the way of several of the rivets.
Here is all of the ribs, but one end rib installed.
I also tried out the flaring tool, since I will need to install the vent line before putting the last end rib in.
Comments